![]() I haven't programmed anything serious for USB but I believe this is 'Command Block Wrapper Command Block' and you would put in vendor specific commands and arguments/parameters. The wiki has some interesting details such as a memory map and some info on commands and interrupts.īasically I believe this project will allow you to use custom code on the controller of a Flash Drive(PS2251-03). Use host/load.py script to load and run test.btpram, observe LED/communicate with the code. ![]() This can be achieved in several ways:ġ.Use host/go_isp.py script to reboot PS2303 from normal mode to BootROM (simplest, temporary)Ģ.Disrupt NAND probing at power up shorting some DATA lines with tweezers (temporary) fast USB 3.0 to FPGA bridge).Ī PS2303-based USB stick must be in BootROM mode to be able to load and run custom code. ![]() This project's goal is to turn PS2303-based USB flash drive into a cheap USB 3.0 development platform (i.e. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |